Make sure to use archlinuxarm mirrors in /etc/pacman. Linux archlinux 5.4.38-1-ARCH #1 SMP PREEMPT Wed May 6 11:05: aarch64 GNU/Linux You'll have a vanilla Arch linux 64-bit (ARMv8) installation. mkfs.vfat /dev/sdX1īsdtar -xpf -C /mnt/rootĤ. Format the paritions and copy the files into the mount points. Write the partition table and exit by typing w.ģ. Replace sdX in the following instructions with the. Type n, then p for primary, 2 for the second partition on the drive, and then press ENTER and then ENTER again to accept the default first and last sector. This has to be done under a linux computer (you can use raspbian :D).Type t, then c to set the first partition to type W95 FAT32 (LBA).Type n, then p for primary, 1 for the first partition on the drive, press ENTER to accept the default first sector, then type +100M for the last sector.This will clear out any partitions on the drive. GNet Solutions Hardware Hacking Raspberry Pi Make sure the system is up to date: Install a few dependencies: Create a 4GB image and mount it to /alarm/. Run fdisk to wipe the SD card and set the boot and rootfs partitions: fdisk /dev/sdX # make sure to change it (X) to your deviceĪt the fdisk prompt, delete old partitions and create a new one: Insert your SD Card and run blkid to see connected device names: sudo blkidįor me the device name was /dev/sda but it might be different for you.Ģ. I was able to install 64-bit archlinux on a Raspberry Pi 4 after seeing answer which contained a link to root filesystems which I then could burn into the SD Card and boot.ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |